What You Need to Know to Drive a Car

Autos & TrucksMaintenance

  • Author Kris Kolanko
  • Published June 10, 2010
  • Word count 853

The first thing that any new driver must do before driving an automobile is to become familiar with all of the automobile safety features and controls. Once you are completely familiar with your vehicle, you are ready to begin. Before pulling away in your car, however, be sure that it is completely safe for driving. Here is a list of points you should always check before starting the engine:

  1. AIl books and coats should be placed in the trunk, so that you have a greater amount of room available for driving unhampered - a safety feature and a comfort feature combined.

  2. Be sure that backseat of the car is clear. If suddenly, any loose articles in the back seat could be hurled to the front, and injury may result.

  3. You should get into the car by the curb side whenever practicable. In some places it is an offence to open the driver's door in any way that creates a hazard to passing vehicles. In automobiles in which this is impractical, or in awkward situations, extreme care must be taken. Always approach the driver's-side door from the front of the car, so that you cannot fail to see oncoming traffic.

  4. AII doors should be locked to help prevent them from flying open in a collision, and to keep anyone from forcing their way into your car if you stop in traffic.

  5. Check to ensure that the parking brake is on to prevent any movement of the vehicle. The gear selector should be in Park before starting.

  6. Make sure that signal lights function properly. (The car will have to be on to check if they are working properly.)

  7. Adjust the ventilation; excessive hear will cause drowsiness, and poor ventilation may create a carbon monoxide hazard.

  8. Adjust the seat so that you can reach all foot pedals comfortably. Also make sure that you have unobstructed vision at all angles. It may be necessary to use cushions to attain this.

  9. Adjust all mirrors so that you can tell at a glance the positions of other vehicles on the road.

  10. Fasten your seat belts. The car should not be put in motion until all belts are fastened and adjusted.

  11. Check that the brake pedal has resistance when you press it. This indicates that there is sufficient brake fluid in the brake lines and that the brakes will function properly. If the hydraulic brakes do not function, do not attempt to get to a garage, but have the car towed there by a tow truck.

  12. Be alert but relaxed. You are no longer a pedestrian. You are in command of a powerful machine that can give thousands of miles of service and satisfaction, but which is also capable of destroying life and property.

Preparing to drive

Getting ready to drive is an important event in a young persons life. Are you emotionally prepared to drive? Are you ready to concentrate all your attention on driving? Do you possess the necessary safe attitude for competent, efficient driving? Are you willing to overlook the mistakes of other drivers? If the answers to all of these questions are 'yes' then you are ready to begin.

  1. Make sure the parking brake is on.

  2. Press the brake pedal with the right foot and hold. The vehicle must not move until you are ready. This step also tests the brakes for proper function, and is an excellent safety precaution. If the brake is working properly, you will be unable to press the pedal completely to the floor.

  3. Move the selector lever to Drive. This is the position for normal driving in most automobiles.

  4. Place your hands on the steering wheel in the "ten-and-two" position.

  5. Always look behind you. Using the mirrors is not enough: there is a "blind spot" that must be checked by looking over your left shoulder.

  6. Signal your intentions, to inform other drivers what you intend to do. (Even at this practice stage, you should perform every step as though you were in regular traffic. This way, the proper techniques will soon become second nature, and you will make the transition from the practice area to the busy street with a minimum of difficulty.)

  7. Remove your right foot from the brake and place it on the accelerator. Your left foot should be used only to engage the parking brake and to change the driving lights from low to high and back.

  8. Release the parking brake.

  9. Gently depress the accelerator. Smooth driving is the mark of an expert.

  10. Re-check the traffic, and move out when the way is clear. Always re-check traffic. You are now on the road. Look ahead and get the complete picture. Know what is behind you, to your left, to your right, and in front.

  11. In preparing to stop, check your blind spot, signal and then pull over to the side of the road when the way is clear.

  12. Brake to a smooth stop. Place the gear selector in Park, turn off the ignition, and remove the key. Engage the parking brake, and, if leaving the car, lock all doors. Leave via the curb side if at all possible.

My name is Kris Kolanko. I am co-owner and operator of the site http://www.wannadrive.com. Our goal is to provide new and current drivers with information and education products that will help them obtain a license or find a driving school, anywhere in the United States. Feel free to explore our site and take advantage of all we have to offer.

Article source: https://articlebiz.com
This article has been viewed 1,101 times.

Rate article

Article comments

There are no posted comments.

Related articles