Four Most Common Roof Leak Locations

Roof leaks are a nuisance for many homeowners. They can be difficult to diagnose - that is a fact. To make matters worse, different weather conditions will produce leaks in different locations.

The vast majority of roof coverings operate using the principal of gravity. This can be a big help in locating a leak source. However, horizontal roof boards can trick you. A leak may actually be eight to 10 feet sideways from where you see the wet ceiling or spot in the attic.

Finding the source of some leaks is easy. Others will require detective work and possibly a garden hose and an inside spotter. If you don't feel comfortable on a roof, you will have to find an honest roofer to assist you. Sometimes this can be as hard as finding the smallest leak! Here are some tips that may help you find a pesky roof leak:

The Field of Shingles

If your roof is older, it is possible that the leak is within the roof field. This means the expanse of shingles, slate, shakes, whatever. If your roof is asphalt, then you can walk around with ease. Other materials such as slate, concrete tile or clay tile may not be so forgiving. You can crack roofing if you walk on it, so be careful. With regular shingles, look at the tops of the vertical knockouts. Look for missing colored granules. Look for cracks. Possibly a nail has backed itself out of the roof sheathing. Simply take your time and hunt.

Chimneys

These devils are the source of many a leak. Chimneys contain four different types of flashing. All must be right or you will have a leak. Plus, the counterflashing that goes into the brick mortar joint must be right. A hairline crack above the flashing can allow vast amounts of water to run behind the flashings. Look for soldered corners of flashing that might have broken or have holes. Do not use caulk to repair these flashings!

Plumbing Vent Flashings

Newer vent flashings are a concern of mine. Many of these incorporate a rubber seal with an aluminum flashing. The rubber can fail in as little as 10 to 15 years. Look for cracked rubber around the plumbing pipe. The flashing should dive up and under the shingles that extend up roof from the middle of the plumbing vent. The bottom half of the flashing should be exposed and actually cover the shingles.

Furnace or B-Vent Flashing

These flashings are basically identical to plumbing vent flashings. However, they sometimes have a metal storm collar. These simply fit tightly around the vertical pipe that exits the roof. If they become loose, the storm collars can cause leaks.

Our free guide reveals tips on how to hire a Lafayette La Roofing Contractor. Avoid getting ripped off by a Lafayette La roofer click the link below and access the guide...