In this the way to information I will be exhibiting you the way create a wireless bridge between a Linksys 160n wi-fi router and a Linksys WRT54GS wireless router that has been modded with the DD-WRT firmware. You may ask your self what is a wireless bridge.You additionally might ask your self why you'd wish to create a wi-fi bridge within the first place. Nicely a wi-fi bridge is once you connect one router to a different router with out using any exhausting wired cables. You could want to create a wi-fi bridge for some of the following reasons.

Pc are positioned at completely different ends of your house and you can't run a ethernet cable between the two router. You want to hyperlink to you neighbors community so you possibly can share internet service, files, and media equivalent to music and movies. The probabilities are limitless in terms of networking routers collectively using wireless.

For the wi-fi bridge setup I can be using the next ip handle and subnet setup:

• Wi-fi Router 1 = Linksys WRT160n 192.168.1.0/24

• Wireless Router 2 = Linksys WRT54GS-WRT mod 10.0.1.0/24

The Linksys WRT 160n wi-fi router will likely be instantly related to the Internet service, and the Linksys WRT54GS DD-WRT modded router will create the wi-fi link between the two routers. The best way to setup your wireless bridge is to have a pc that has both a wifi connection and a ethernet connection. To begin the set up, use your wireless connection to connect with router 1, which is the Linksys WRT160N. After you will have connected the router, open your web browser and kind in the default gateway which ought to be 192.168.1.1. Click on the Standing Tab and make sure that router 1 has a web connection.

After you understand that the primary router has a internet connection, go to the Wi-fi Safety Tab and setup the encryption type and paraphrase key. Make sure that you are utilizing suitable encryption between both of the routers.linksys-wrt160n-wpa-wi-fi-security

After you might have set the encryption kind and key on the primary router, disconnect from this router. Now connect with the WRT54GS DD-WRT modded router, then go to the setup tab and alter the native community to 10.0.1.0 or whatever network vary you prefer.

• Local Ip Address: 10.0.1.1

• Subnet Mask: 255.255.255.0

• Gateway: 10.0.1.1

• Local Dns: 10.0.1.1

After you have got modified the community setup in your modded DD-WRT router, disconnect from the router then reconnect to so that you just obtain your new ip address. Your new ip handle needs to be someplace inside the 10.0.1.zero network. Now open an internet browser at level it towards 10.0.1.1, which is now the default gateway in your WRT54GS DD-WRT modded router.

Now go to the status tab and click on the wireless tab. Throughout the wireless tab it is best to see a button that says site survey. The location survey button is located towards the bottom of the page. All it's a must to do now's select router 1 from the list, which ought to be the Linksys WRT160N.

After you've chosen router 1 from the list, go to the wi-fi tab and click on the wireless security tab. All it's important to do now could be enter the very same encryption kind and key that you simply setup for router 1. After you've set the encryption sort and key into ybur modded DD-WRT router, all it's a must to do is apply the settings. You should now have a wireless hyperlink between the Linksys WRT160N and the Linksys WRT54GS. Now join using a wi-fi connection to the DD-WRT modded router, and ensure your web connection work.