Having a hot tub is one way for homeowners in the cold northern states to stay warm in the winter. Hot tubs in CT, NY and NJ, for example, are a hassle-free way to relax at home after work or after shoveling snow off the driveway or even the roof. While they do require some maintenance, the routine is relatively simple. When it comes to filters, there are several different types. The frequency that filters are changed depends on the type of spa and the size and frequency of the system used.

What It Does

The primary purpose of hot tub filters is to keep water clean. Water runs through the filter where all of the fine particulates are trapped and prevented from circulating throughout the spa system. This prevents hair, skin, leaves and other debris from floating through the water indefinitely. The filter is usually changed when the spa water is changed. They may need to be cleaned more frequently, depending on the use and upkeep of the spa.

The complexity of the filters ranges from multiple layers to just a few. This affects the amount of time it takes to process all of the water in the spa and how clean the water becomes.

Cartridges

Filter cartridges are made of mesh materials. They trap the debris in the filter and prevent its circulation. Usually resembling a round cylinder with a hole in the middle, cartridges are made of polyester or ceramics. Specific sizes and types are required to coordinate with different brands and models of hot tubs. Each specific unit does not have to be made by the same manufacturer as the spa itself. There are many different types of compatible ones that can be used instead.

Microban Filters

Left undisturbed, the hot water in spas is ideal for the microorganisms to thrive. They can cause stains, algae and odors. Special filters that protect spa water from growth of bacteria and microscopic living organisms are called anitimicrobial or microban filters. Without these devices to act as a neutralizer, mold and mildew can double in mass every 20 minutes. The most common material used to make microban filters is polyester. Other man-made synthetic blends are used instead of or in addition to polyester, depending on the manufacturer.

Flossers

When a filter becomes full of debris, it may be necessary to clean it without having to replace it. This can be done using a filter flosser. Flossers are usually attached to a garden hose to clean out debris with a strong stream of water to prolong the filter’s usefulness.

If you are interested in hot spring filters and/or hot spring tri x filters, be sure to visit www.priscospas.com.