Every schoolboy loves a joint to escape and call their hold. Because we have wood all-around our home was not demanding for a band of trees that we have to to find. If in your case you do not have the same luck, you can benefit from equivalent theory of building, but using 4x4 posts sunk into the base as well.

A trip to the lumber yard of material, as well as, six 2x4x8, 8 4x8 sheets of 1 2 "plywood, 1" wood screws, 2 "wood screws, 12x12 tarp, four bungee cords, six little hinges, 2 medium hinge, a slide lock and orange marking aerosol paint |. Before you add the additional end to the tree that you take a level and ensure that your tree home will not be running down hill |. One foot higher than the roof of your house you will add your part of the tarp in and attach bungee cords to the four trees to cover you from the basics.

Goals trees from the ground up to the at the same height of the ground you prefer your tree house to be and brand it with paint. Later than you have marked all four of your trees lay your 2x4x8 on the base and use your Bosch compound miter saw and Bosch Compound miter saw stand, cut two of your 2x4 in half giving you 4 2x4x4's. In a closing and someone to assist keep on the wood take 2 of the 2x4x8 pieces and attach using the 2 "wood screws to the tree with your paint brand as a guide. 2 of 8 With 'trees now with the launch of a wooden frame you take April 2 "pieces and add them at both ends inside the trees.

Book a piece of plywood and place it on bodywork and secure along to 2x4's with 1 "wood screws and be absolutely to swallow all the screw heads so they will not be a danger |. The after that action is to measure 8'from deck up the 4 trees and check another time with your paint. You now have the lower frame made for your floor. Repeat the liquidize of expanding the 2x4's over you. When it is finished, you will crave help lifting one of the plywood sheets on top of the frame and screw down firmly, this will serve as your roof. Use the waste 6 sheets of plywood and install your walls before you do that you should cut a rectangular window of three panels avoid the cut out bit and a door on a panel successively saves the bit cut out.

Spend less hinges and takeout square pieces of the window, attach the hinges to the small panel outwardly of the best window frame and you now have a window you can prop access with a plank for ventilation. Remove the medium and hinges attach to the side of your exit and the glide lock in the middle of the differing door and hang your hinges outer.